Part 2 - tooling up

I was thinking of calling this port 'tooling around' because that probably best sums up what I've been doing for the last month. No-one cares about that though, instead Im going to run through the process for creating all the moulds needed for the new build.

Because I still have access to the CNC router - its now being housed by my mates at

The MDF/ply bits are now pretty straight forward. I've learnt that it's better to cut them with a much finer stepover (1.2mm or so) so that you almost don't need to sand them. It takes a bit longer on the machine, but saves you lots of stuffing around later. Then one coat of resin and a sand and they're good to go. The foil strut mould was the last thing I did, and turned out the best.