Since starting to work in my shop "full time", I have yet to put a full day in due to a neck injury and complicated planning to adopt a girl from China. Nevertheless, some light duty work is getting done, namely the modeling of the Deblois Street Dory for a customer, some marketing work (such as starting the blog!), and some prep work for some spar and oar making. We ordered several hundred dollars worth of carbon fiber and other supplies for making the carbon blades with the Vacuum Infusion Process (VIP). More on that later when we get started with infusing the blades.
For now, check out the dory model lines which have been finalized on the model and will be transferred to the plans tomorrow for the customer. Each batten that you see represents the overlap of the planks, the "lap" width, roughly 1". So the lower edge of each batten, made out of 1/4" x 1/8" pine strips, represents the bottom of the plank. They were hot glued on by eye and adjusted until it looked "right". The next step, after drawing these lines on the paper plans, is to draw the construction and sail plans. The customer will be building this Fall.
0 comments:
Post a Comment